This command will add a pinpoint to solid's polyline. Pinpoints
are used to subdivide solids for assignment in the Solid Timing command.
Pinpoints will appear on the 3D polyline as a sphere, as shown
below.
Prompts
Command: addpinsolid
Select solid polyline:
Here the user will
need to select the 3D polyline to add the pinpoint.
Pick pinpoint or Enter distance or Define
size[<Pick>/Enter/Size]:? S
Using
the Size option will allow you to change the size of the pinpoint
symbol.
Pinpoint sphere diameter size <10.00>: 15
Pick pinpoint or Enter distance or Define
size[<Pick>/Enter/Size]:? P
Using
the Pick option will allow you manually select the location of the
pinpoint. Using the Enter option will allow you to set the location
of the pinpoint by entering the distance from the start of the
polyline.
Pick point on selected polyline:
The
Nearest Snap will be activated and you will be able to pick a
location on the polyline. The command will end after picking a
location.
Pulldown Location: Solid
Keyboard Command: ADDPINSOLID
Prerequisite: A Polyline with a solid assigned (see Assign
Solid to Polyline command)
