Compliance Drillhole Report

This command reports drillholes from the selected drillholes that meet all the qualities defined in a parameter file. Drillholes that don't meet the parameter file are not reported. There are three main prompts you may receive after defining the parameters.

1) Process beds [Yes/<No>]?
This option determines if the program will read the strata names exactly as they exist in the drillhole, or if they will be regrouped by the bed names. This is very important if you are trying to test a parameter on a single strata sample, or a composite bed group. For example, suppose you have multiple thin samples of strata in a single bed, and you want to check for drillholes where the total bed thickness is greater than 5 ft. If you do not enter a YES for the Process Beds option, the program would only analyze the thickness of each individual strata in the bed, as opposed to checking the full bed thickness.

It is also important to note that when answering YES to this prompt, the strata names will not be considered, but rather, the regrouped bed name. For example if the strata name is "COAL", the Bed Name is "A", and the Key status is KEY, then the regrouped name would be "A_KEY". In this scenario, checking for the existence of COAL when you enter Yes to this prompt would yield no results. For more information on the regrouped names, see the Bed Name Suffixes section of Carlson Configure > Mining Settings.

2) Analyze entire drillhole or specific strata [<Drillhole>/Strata]?
The entire drillhole method will include the drillhole in the report if any of the strata meet the parameter file.
The specific strata method checks only the selected strata and includes the drillhole in the report if the strata meets the parameter file. When using the Strata option, a dialog will appear with the list of available strata layers.

3) Require all strata to match or any strata [All/<Any>]?
This option will only appear if a Strata Name has not been specified in the Parameter File. With this option, you can specify if all strata that are checked must pass the tests of the .par file, or if only one strata must pass the tests.

After these prompts, a text report will be displayed that shows a list of all of the drillholes passing the tests specified in the .par file. It is important to note that the entire drillhole will be reported, and not simply the strata that were tested.

Prompts

Parameter Dialog
Process beds [Yes/<No>]? Y
Analyze entire drillhole or specific strata [<Drillhole>/Strata]?
Require all strata to match or any strata [All/<Any>]?
Select the Drillholes to test.
Select objects: Specify opposite corner: 13 found
Compliance Drillhole report

Pulldown Menu Location: Drillhole > Parameter Compliance
Keyboard Command: charea3
Prerequisite: Drillholes