This command connects sequential dashes into polylines. There are
two processing methods. The Individual method creates one polyline
at a time. The Selection method processes a selection set of dashes
and creates multiple polylines. The program will prompt you to
select a sample and adjacent dash line. This identifies the layer
and approximate gap between dash lines. It is helpful to isolate
this layer before running the command. Next, select the dash lines
to process and press enter. Below are typical results of the
conversion.
Before Conversion
After Conversion
Pulldown Menu Location:
PDF Keyboard Command:
dash2pl Prerequisite: Dashed
linework to convert into continuous polylines.
