This command generates multiple strata surfaces based on strata
definitions and placements of drillholes. Strata surfaces are
generated at the bottom of each strata. These strata surfaces
can then be used in other TakeOff commands like Calculate Total Volumes. They can be
viewed on screen, through the command Draw Strata Surface.
This command also builds the water table surface when the
drillholes have water table elevations specified. The water table
surface is independent of the strata surfaces. When you have a
water table surface, you can use it in other commands such as
Draw Strata Surface. The water table surface is also used in
Calculate Total Volumes to report cut quantities below the
water table.
Note: By observing the
command line, one can see the status of each strata surface
generation.
Keyboard Command:
tk_chgrid Prerequisite: Define
Drillhole/Strata Settings, Place Drillhole