Select by Length

This command builds a selection set of linework objects in the drawing based on linework length. The length filter can be setup to get linework greater than or less than the specified value, or between two length values. After specifying the length criteria, the program prompts for selecting the linework to check. The program then builds a selection set of those objects that pass the length filter. Then to use this selection set in other commands, enter "P" for previous at the "Select objects:" prompt.

Prompts

Select by greater, less or between lengths [<Greater>/Less/Between]? press Enter
Enter length for greater than: 1000
Select objects to build selection set.
Select objects: pick linework to filter

Pulldown Menu Location: Edit > Selection Sets
Keyboard Command: lenselect
Prerequisite: None

Converted from CHM to HTML with chm2web Standard 2.85 (unicode)