Draw Pillars creates a polyline in the PILLARS layer out of the
points you pick. These points should compose the perimeter of a
pillar. It is necessary to end picking points by entering C in
order to make a closed polyline. Otherwise, inaccurate tonnages may
result. Before using this routine, the points to connect can be
placed using one of the Mine Note Entry commands. If, after drawing
a series of pillars, you want to check to see that all of the
pillars have been properly closed, use the Highlight Unclosed
Polylines under the Works dropdown menu.
[node on] First Point: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: C to close
Pulldown Menu Location: Works
Keyboard Command: pillars
Prerequisite: None