This command shows a solid model in the 3D Viewer Window. See
the 3D
Viewer Window section of the manual for a description of the
viewer functions.
Solid Edit is an extra feature of View Solid that isn't part of
the regular 3D Viewer command. To use the Solid Edit, switch to the
Pick Mode by picking this button: The Solid Edit has functions to remove faces
from the solid which can be used to clean up a solid. Removing
faces will leave holes in the solid. To make the solid watertight
and fill in the holes, you can run the Heal Solid command after
View Solid. There are two modes to the remove functions. The Remove
Single removes only the face that is picked. The Remove Radius
removes all faces from the pick point that are withing the
specified radius.
Pulldown Menu Location: Solid
Keyboard Command: view_solid
Prerequisite: solid model .mdl file