Perimeter
Perimeter is a 2D polyline that all points on it have the same
elevation. It can be used as boundary polyline of your targets on
your drawing. This command allows you to digitize a perimeter by
picking points on the drawing. While digitizing a polyline, the
command keeps prompting you to pick next point until your
press Enter to finish digitizing, or
press A on the puck or
enter Close on the keyboard
to close the polyline on itself . If you make a mistake,
press B on the puck or
enter Undo on the keyboard
to remove the mistake and then continue to digitize. After
finishing a perimeter, the command prompts your to digitize another
polyline until you press B
or enter No.
Prompts
First
point: pick a point on the drawing using
puck
Segment length: 0.00, Total
length: 0.00
Close[A]/Undo[B]/Pick next point
(Enter to end): pick next point
Segment length: 104.27, Total length: 104.27
Close[A]/Undo[B]/Pick next point
(Enter to end): pick next point
Segment length: 153.14, Total length: 257.41
Close[A]/Undo[B]/Pick next point
(Enter to end): pick next point
Segment length: 104.89, Total length: 362.30
Close[A]/Undo[B]/Pick next point
(Enter to end): press Enter to finish the perimeter, or press
A to close the perimeter
Digitize Another PERIMETER
Polyline [Yes(A)/<No(B)>]? press A or enter Yes to continue digitizing
another perimeter, press B or enter No to finish digitizing
perimeters.
Keyboard Command:
dig_perim
Prerequisite: Have a
digitizer board and a puck connected to your computer, and have
Wintab driver installed. The digitizer has been correctly set up.
Have done tablet calibration for current drawing.