This command draws lots based on a front and back polyline. Starting from the front polyline, the program calculates two lot side lines perpendicular from the front polyline that intersect the back polyline and create the specified lot size. Lots are created along the front polyline in the order that the front polyline is drawn. If the front polyline needs to be reversed, use the Reverse Polyline command found on the Edit menu. The direction of the back polyline does not matter. The lots can be drawn as closed polylines or just the lot sides can be drawn. There is also an option to automatically create all the possible lots at the specified area between the front and back polylines or to prompt for each 0.4 acre lot.
In prompt mode, the program reports the remaining area between the front and back polylines and then asks for the lot size. The lot size can be specified either by area or frontage along the front polyline.
The lots are sized to meet the specified area and also meet the
minimum frontage and backlot distances. The program starts by
checking the lot area at the minimum distances. If this area is
greater than the target, then the lot is drawn at the minimum
distance and the resulting lot area will be greater than the target
area. Otherwise the program will increase the frontage until the
lot reaches the exact target area. The Use Frontage Setback
Polyline option allows you to use another polyline besides the
actual frontage polyline for the minimum frontage indicator.
Typically, this Frontage Setback Polyline would be offset a set
amount from the actual frontage polyline.
Lot Layout dialog
Select front polyline: pick a polyline
Select back polyline: pick a polyline
With prompt for each lot active:
Area remaining: 160326.88 S.F, 3.6806 Acres
Quit/Frontage/Enter lot area (Acres) <1.2269>:
1
Area remaining: 116766.88 S.F, 2.6806 Acres
Quit/Frontage/Enter lot area (Acres) <1.0000>:
F
Enter Frontage <50.00>: 75
Lot Area: 37807.50 S.F., 0.8679 Acres
Area remaining: 78959.38 S.F, 1.8127 Acres
Quit/Area/Enter frontage <50.00>: A
Quit/Frontage/Enter lot area (Acres) <1.0000>: press
Enter
Area remaining: 35399.38 S.F, 0.8127 Acres
Quit/Frontage/Enter lot area (Acres) <1.0000>:
Q
|
Polylines for Lot Layout The Front Polyline goes from right to left |
|
Resulting lots numbered using Sequential Numbers |
Pulldown Menu Location: Area/Layout
Keyboard Command: lotlay
Prerequisite: A frontage polyline and a backlot
polyline.