This command labels top of curb and/or bottom of curb (flowline)
elevations with a leader along an alignment. The data to label
comes from Carlson points and alignment is defined by a selected
polyline. The program reads all the points in the drawing and then
you select which descriptions to use the top of curb labels and
which to use for the bottom of curb labels.
There are separate settings for the top and bottom to control
the label prefix, suffix and decimals. The Tolerance setting is the
maximum distance between a point to label and the polyline. The
Leader Bearing determines how the Leader Angle is applied: Relative
adds the angle to the alignment polyline and Absolute means based
on the orientation of the screen. The Text Horizontal Offset Scaler
controls the distance between the alignment polyline and the label.
The Text Vertical Offset Scaler controls the buffer offset between
the leader line and the label. The User Leader Entities option
chooses between drawing the leaders as polylines or as leader
entities. The Elevate Annotations setting controls whether the
labels are created at their elevation or at zero.
Top Curb Descriptions pick descriptions to label for top of
curb
Bottom Curb Descriptions pick
descriptions to label for bottom of curb
Pick a polyline to annotate (Enter to End): pick a polyline
Pick side for flowline (Enter to End): pick a side
Pulldown Menu Location: Annotate
Keyboard Command: cflelev
Prerequisite: points with elevations and descriptions, and
alignment polyline