This command will label and report the interior, exterior and deflection angles between two directions. The angles can be defined by three points, or by two line or polyline segments that have a common endpoint. An example of labeling interior and exterior angles is shown below. The Both option will label interior and exterior angles simultaneously.
At the Command line, type O for Options to bring up the options
dialog. There are settings for the angle format as degrees, minutes
and seconds, or as decimal degrees. You can also control the number
of decimals and choose whether to draw dimension leaders for the
interior angle labels.
Define angle by [Options/Points/<select line or
polyline>]: pick a polyline segment
Select adjoining line or polyline: pick another polyline
segment
Interior: 64d15'01" Exterior: 295d44'59" Deflection:
115d44'59"
Angle to label
[<Interior>/Exterior/Both/Deflection/None]? press
Enter
Typing B for Both labels both the interior and
exterior angles.
Define angle by, Points/<select line or polyline>:
press Enter to end
Pulldown Menu Location: Annotate
Keyboard Command: labang
Prerequisite: None