This command attaches a pit name and site name to closed polylines that are used as inclusion or exclusion perimeters routines like Surface Mine Reserves and Surface Equipment or Production Timing.
Label area names [<Yes>/No]? Choose whether or not
to label.
Text height <4.00>: press Enter to accept 4 drawing
units (ft or m tall) or enter a new text height
Auto place labels in center [<Yes>/No]? press Enter
to accept To manually pick the label position, answer No to
this prompt.
Prompt for inclusion, exclusion or
both [<Inclusion>/Exclusion/Both]? Bfor
Both.If you are only choosing inclusion areas, then you can
answer Inclusion to this prompt to skip the exclusion polyline
prompt and speed up entry. Or you can use Exclusion if you're just
going to add exclusion areas to existing inclusion pit
areas.
Site name <Site 1>: press Enter to accept Site 1, or
type a new site name
Pit name <Pit 1>: press Enter to accept Pit 1, or
type a new pit name
Select Inclusion perimeter polylines.
Select objects: pick closed polylines for areas to include
in calculations
Select Exclusion perimeter polylines.
Select objects: pick closed polylines for areas to exclude
from calculations
Specify another area [<Yes>/No]? press Enter to
accept Yes or type N for no If you do specify another area,
then the Site Name remains the same, but the Pit Name is
automatically incremented by one for efficient naming.
Pulldown Menu Location: Boundary
Keyboard Command: pitname
Prerequisite: Closed polyline