This command reports the pit name and site name that are
attached to the selected polyline at the command line and shows the
pit graphically with a yellow solid fill.
Pick inside pit polyline to identify (Enter to end):
pick inside a polyline If you pick on or near a common line,
one pit is highlighted and you are prompted to Press N for next
selection or Enter to accept current, highlighted pit line. The
selected pit line is filled with a solid yellow hatch that erases
when the next pit is selected, or the command is finished.
Site Name: Site 1
Pit Name: Pit 1
Select pit polyline to identify: press Enter to end
Pulldown Menu Location: Boundary in the Advanced Mine
Module
Keyboard Command: pitid