This command is used on stockpile projects to regrade the fill
slopes of the cross sections with less steep slopes while
maintaining the same end areas. The slope portion of the cross
section to regrade is identified by entering the section
descriptions for the top and bottom points.
Select existing section file Pick a section file to
read
Specify new section file to Output Enter a section file to
create
Target Slope
Percent: 80
Top of Slope Offset Description: TB
Bottom of Slope Offset Description: BB
Pulldown Menu
Location: Sections > Section Utilities
Keyboard Command: regrade_slope
Prerequisite: A section (.SCT) file