This command links lines and polylines with points so that the
linework updates if the points are updated. This link is the same
as option under Carlson Configure > General Settings. The option
in Configure is applied when the linework is created. This separate
link command allows you to add links on selected linework in case
the Configure link option was off when the linework was
created.
In order to link points to the linework, the program matches
points from the current coordinate file to the linework vertices.
The Vertex Tolerance is how close the coordinate point needs to be
to the linework vertex to create a link.
To remove point links, run File > Drawing Utilities >
Remove Reactors.
Enter Point to Vertex Tolerance <0.001>: press
Enter
Select Lines and Polylines to Create reactors
for.
Select objects: pick the
linework
Pulldown Menu Location: Points > Point Utilities
Keyboard Command: linkline
Prerequisite: Points and linework