This command allows you to move block attributes and to draw a
dynamic leader to block insertion point. Leaders and arrowheads may
be customized by selecting Options at the command line. The
attributes are always justified left or right depending on which
side the leader starts. The Restore option prompts to select a
moved attribute label and then puts that block attribute back to
the default position.
The Options dialog has these settings.
Minimum Leader Length
Scaler: Specifies the minimum length, in terms of multiples
of the attribute block's height, that the leader must be.
Prompt for Curved Leader Points: This option prompts for
additional leader points and creates a smooth leader that goes
through all the leader points.
Draw Horizontal Leader
Tick: Specifies whether or not to draw a terminating tick (a
short horizontal line segment sometimes referred to
as a "hook line").
Draw Arrowhead: Specifies
whether or not to draw an arrowhead at the end of the leader that
points to the point entity.
Minimum Leader for Arrow
Scaler: Specifies the minimum length of the leader, in terms
of multiples of the attribute block's height, that the leader must
be before an arrowhead is placed on it.
Arrow Size Scaler: A scale
factor to apply to resize the arrowhead symbol.
Leader Offset Scaler: A
distance indicating the desired offset from the point node to the
tip of the leader.
Use Separate Leader Layer:
Specifies whether or not to use a layer other than that of the
identified point for the leader. Use the Select button to choose an alternative
layer for the leader.
Select Label to Move [Options/Restore]: select block
attribute
Pick label position: pick point
Select Label to Move [Options/Restore]: press Enter to end