This command combines linework entities to create a polyline.
This command is similar to Join Nearest. The difference is that
this command processes a single polyline at a time instead of a
selection set of polylines. This command prompts for a linework
entity to start joining from. Then the program looks in the drawing
at other linework to join to this polyline using the filter options
from the dialog. All the options in the dialog are the same as Join
Nearest except the Prompt For Linework To Join option which prompts
for other linework to join to the polyline once the program has
finished tracing. See the Join Nearest section of the manual for
descriptions of the other options.
Join Polyline By Trace dialog
Select line, arc or polyline to join: pick an entity
Select entity to join to start (Enter for none): press
Enter
Select entity to join to end (Enter for none): press
Enter
Pulldown Menu Location: Edit > Polyline Utilities
Keyboard Command: joinpoly
Prerequisite: Linework to join