Reduce Map Check File
If a map check file is not open, a file dialogue box will appear,
allowing you to open an existing map check file. If you wish the
coordinates to be adjusted, select the type of adjustment in the
Traverse Options dialog box. If a coordinate file is not open, a
file dialog box will appear allowing you to open one.NOTE You
may use the same coordinate file as often as you wish. Make
sure the correct coordinate file is open.
Prompts
Next Enter Point values:
the starting Point number,
Northing and Easting and the ending Northing and
Easting:
The map data will then be
reduced and the coordinates stored in the coordinate file.
Overwrite protection is in place in case the points already exist
in the coordinate file. If a point already exists in the coordinate
file you will have the following options:
CANCEL: will terminate the process of
storing coordinates.
OVERWRITE :will overwrite
the existing point.
DO NO OVERWRITE: skip to
the next point. If you have the “Do Not Ask Again” box checked.
Overwrite will overwrite all points without asking, and Do Not
Overwrite will only write NEW points to the coordinate file.
The initial closure information will be shown. For example:
Correct Ending Coordinates, North: 5000.0000 East: 5000.0000
Ending Coordinates, North: 5071.8346 East: 4894.7441
Error, N: 71.83 E: -105.26 Total: 127.43 Brg: S 55ø41'15"E
Distance Traversed: 1308.19 Closure: 10
A full report including acreage may be viewed by pressing the F2
key to view the CAD Text Window. You may also view/print the
display file.
Pulldown menu Location:CGTrav
Keyboard Command:RDM,
CG_REDUCE_MAP
Prerequisite: Open
Coordinate File