You can select any one of the
methods you wish to use to use to choose the points by clicking one
of the methods of point selection in the
Choose Points section of the
dialog. You may also specify whether you wish to
Include or
Exclude the points chosen. If you
include the points, they will be added to the list from the
coordinate file. If you exclude the points, the points chosen
will be removed from the list of points previously
Included. The method of choosing
the points is very much like using the
Choose initial points for base
selection set from coord file. (Enter when done)
[All/Block/Code/Desc/Elev/Pt-group/Limits/Radius/Select]:
prompt. For example, if you choose the
Include radio button and the
All radio button then click
on the
<Add button, all
the points in the coordinate file will be shown in the list on the
left side of the dialog. If you then choose the
Exclude radio button and the
Block radio button, fill in
the block of points you wish to remain in the list, then all but
these points will be excluded from the list when you click the
Remove> button (see the
example dialog below).
When the points you wish to import
are all in the list on the left, click OK.
CAUTION: If
the points that are being imported exist in the current coordinate
file, they will be overwritten without warning!
Export Points - click the
Export Points button to
copy points from the current coordinate file into another
coordinate file. You will be asked to specify the file to
export the points into then, similar to importing points, use the
C&G Select Points from:
dialog to select the points to be exported. Click OK in the
C&G Select Points from:
dialog to export the points.
CAUTION: If
the points that are being exported exist in the file they are being
exported to, they will be overwritten without
warning!