Creating a Solid
To create a Solid from a Cloud, right-click the Cloud and select
Create Solid.
Tolerance: Helps remove outlier points. If the
resulting surface is too spiky, adjust this value higher.
Precision: Uses tighter calculations for
pre-processing. Will result in a tighter grid.
Range: If the mesh does not span over expected gap
areas, raise this value higher. If the surface spans over
unexpected areas, lower the value.
Tightness: Used for determining the density of the
triangles. The higher the value, the smaller the triangles of the
resulting solid.
If only the floor has been surveyed, you can create a 2D
solid. The Tightness value does not matter for this type of
triangulation.