This command adjusts an image to fit control points. This image
adjustment applies when the image distortion varies and requires
more than a single translate, rotate and scale transformation. The
control points are defined by screen picking a point on the image
and then the point to move this point on the image to. In the
example shown here, the roads in the image don't line up with the
road linework. After picking the road points on the image and the
corresponding points on the linework, the image is adjusted to fit
the road linework.
Image before Rubber Sheet showing control
pointsImage
after Rubber Sheet
Prompts
Pick origin of control point 1:pick point 1 Pick destination of control point 1:pick point 2 Pick origin of control point 2:pick point 3 Pick destination of control point 2:pick point 4 Pick origin of control point 3 (Enter to end):pick point
5 Pick destination of control point 3:pick point 6 Pick origin of control point 4 (Enter to end):pick point
7 Pick destination of control point 4:pick point 8 Pick origin of control point 5 (Enter to end):press
Enter
Pulldown Menu Location: Raster Keyboard Command: rasrubber Prerequisite: an Image