This command revises a segment of a contour polyline. Begin by picking a point on the contour where you want to start editing. Then pick new points for the polyline. When finished picking new points, press Enter and then pick a point on the contour to connect with the new points. The polyline segment between the start and end points is then replaced with the new points.
Select contour to edit: pick the contour polyline at
the place to start editing
Pick intermediate point (Enter to End): pick a
point
Pick intermediate point ('U' to Undo, Enter to End): pick
a point
Pick intermediate point ('U' to Undo, Enter to End):
Press Enter
Pick reconnection point on contour: pick the contour
polyline at the place to join