Assign Contour Elevations - Single Elevation Group

This command changes the elevations of polylines and can be used to set the elevations of contour polylines. The routine begins at a specified elevation and prompts for a selection set of polylines to set to the elevation. Then the routine repeats using the last elevation plus the elevation increment. Enter an empty selection set to exit the routine.

Prompts

Starting elevation <0.0>: 500.0
Contour interval (negative for down) <1.0>: 5.0
Select polylines to set to elevation 500.0.
Select objects: pick the polylines
Select polylines to set to elevation 505.0.
Select objects: pick the polylines
Select polylines to set to elevation 510.0.
Select objects: Press Enter

Keyboard Command: setcelev
Prerequisite: polylines