Edit Drillhole
This command allows you to screen pick an existing drillhole and
edit its properties. When you select Edit Drillhole from the Drillhole menu, a command prompt
shows:
"Select Drillhole to edit:" Move your pointer around the
screen to pick the drillhole you want to edit. Once a
drillhole is picked on the screen, the following dialog box
appears:
●
Edit: Make changes to
the highlighted strata name. Thickness, Bottom Elevation,
Depth.
● Insert Above: To add a Strata
above the highlighted strata name.
● Append to
Bottom: To add a strata to the bottom of the available
strata name list.
● Remove:
Removes a strata from the available Strata Name list.
● Surface
Elevation: This field can be set by you to establish
the surface elevation of the drillhole.
● Drillhole Name: The
name of the drillhole
● Description:
The screen display description of the drillhole
● Adjust Bottom
Elevations: Will make adjustments to the bottom
elevation based on thickness changes.
● Adjust Next
Thickness: Will adjust the next thickness to hold the
bottom elevation unchanged.
● Save: This
command saves this drillhole as listed.
● Zoom In: This
increases the magnification of the black view window, cross-section
view of the drillhole.
● Zoom Out:
This decreases the magnification of the black view window,
cross-section view of the drillhole.
● Cancel: Ends
Drillhole placement routine without making changes.
Keyboard Command:
tk_chedit
Prerequisite: drillhole
information