This command draws a series of parking stalls. The command prompts for stall width and length, stall parking angle, and side for stalls. Stalls can be located by the number of stalls in a direction, as many as fit between two points, or along a polyline.
Stall Layout Method: Indicate the method of stall creation whether it be a desired number of stalls or as many stalls as can be fit on an alignment.
Min Stall Width: Indicate the minimum width a stall can be when the Fit on Alignment option is specified.
Max Stall Width: Indicate the maximum width a stall can be when the Fit on Alignment option is specified.
Stall Width: Indicate the stall width when the Number of Stalls option is specified.
Number of Stalls: Indicate the desired number of stalls when the Number of Stalls option is specified.
Stall Length: Indicate the desired length of each stall.
Angle of Parking: Controls the angle of the stalls from the alignment.
Adjust Length for Angle Method: When the stalls are not perpendicular, this setting controls whether the stall length is measured along the stall line or as the perpendicular offset from the curb alignment.
Side for Stalls: Indicate the side to which the stall lines should be placed.
Stall Placement Method: Indicate the method by which the stall direction should be determined whether it be between two picked points or along an existing graphical alignment.
Locate on Real Z Axis: Controls whether the stall lines are created at zero elevation or the elevation of the alignment.
Draw Label: This option labels the number of stalls using the Text Size Scaler, Label Prefix and Suffix settings.
Layer: Specify the layer on which parking lines should be placed or click the Set button to choose an existing layer.
Starting Point?
Pick point or point number:
Pick a point
Ending Point?
Pick point or point number:
Pick a point
Created 10 stalls.
Pulldown Menu Location: Area/Layout > Layout
Utilities
Keyboard Command: parking
Prerequisite: None