This command draws a tree line as you move the cursor. At the
first prompt, you can type O for Options and set the Interval
Scaler which controls the spacing of the bubbles. Also at the first
prompt, you can type P for Polyline and then select an existing
polyline to convert into a tree line. At the end, there is an
option to flip the side for the bubbles in case they came out on
the opposite side.
The resulting tree line after you pick point to end |
Pick First Point [Options/Polyline]: pick a point
Sketch treeline (pick point to end): slowly move the cursor and pick a second
point to end the routine
Reverse direction [Yes/<No>]? press Enter
Pulldown Menu Location: Annotate > Line Types
Keyboard Command: treeline
Prerequisite: None