This command prepares a road design for median transitions by picking a plan view polyline for the median alignment and then creating the road design files for a median for the Template Point Centerline (.tpc) and Template Series File (.tsf).
Before running this command, draw a polyline for the median in plan
view. The road centerline must cross through the median as shown
here.
Also before running this command, use
Design Template to make two template files (TPL) where one template
has the median and the other is without the median. In the example
shown here, this template has the median with the grade of MED and
the curb. The template without the median in this example does not
have the MED grade and curb.
In the dialog
for this command, select the input files for the centerline and
template with and without the median. Also set the grade ID from
the template for the median.
Finally, after the dialog the program prompts to select the
median polyline from the drawing. Then the output Template Series
File will assign the median and non-median templates based on where
the centerline crosses the median polyline. The output Template
Point Centerline will assign centerlines for the median using the
median polyline.
To apply the median design, run Process Road Design or Road
Network and use the Template Series File (TSF) and Template Point
Centerline (TPC) for the road design input.
Pulldown Menu Location: Roads
Keyboard Command: prep_median
Prerequisite: Centerline, templates and median
polyline