Story Stake By Points/Polyline

By Points
This option creates a report of cut/fill slopes and distances of a design surface from point to point. First you select the starting point. This starting position is shown as point 100 in the drawing below. Next you enter the subsequent point numbers to get the direction. The resulting horizontal distances and slopes are shown in a report dialog.

If the use Progressive Story Stake Method is turned off, the Cut/Fill, Distance and Slope is calculated from the first point to each point. The result is shown below. If it is turned ON, then it is point to point.

By Polyline

This command creates a report of cut/fill slopes and distances of a 3D polyline across a design surface. First you select the 3D polyline. The resulting horizontal distances and slopes are shown in a report dialog. The same applies for the Progressive Story Stake Method when using the 3D Polyline.

Pulldown Menu Location: 3D Data >> Story Stake
Prerequisite: Screen entities such as 3D polylines and contours
Keyboard Command: story_report