This command creates fault polylines by reading data from a text
file. Each row in the file is for a fault vertex. The data must
include the X, Y and Z position plus the fault shift amount and dip
angle. There is also an optional Description field which can be
used when there are multiple faults in the same file. Use the End
Fault Description as the description in the text file on the last
point in the fault to identify where the fault ends and the next
fault will start.
After selecting the text file to import, there is a dialog to
define the format of the text file followed by a dialog for the End
Fault Description and layer for the fault polylines to create.
Text File to Load
Text File Import Options dialog
Import Faults dialog