Compliance Areas from Drillholes

This command draws a closed polyline(s) and hatches the area(s) that meet the specified values for parameters. It is similar to the Parameter Compliance from Grids, but this analyzes drillholes instead of grids.

The Set Parameters window is for selecting the parameters and values. In this example, two seams BTU are analyzed, so they are both entered in the Strata Name column.

Prompts

Use position from another file or pick grid position [<Pick>/File]?
Pick Lower Left grid corner <1.45504e+006,1.96932e+006>:
Pick Upper Right grid corner <1.46634e+006,1.97717e+006>:
Analyze entire drillhole or specific strata [Drillhole/<Strata>]? S
Select the Drillholes to test.
Select objects: all
19 found
Select objects:
Reading points... 18
Reading points... 0
Inserted 19 points.

Pulldown Menu Location: Drillhole > Parameter Compliance
Keyboard Command: charea