X Intersections
The radius, PC and PT points for each fillet will be calculated and
stored. If Auto Line Plot is on, the fillet arcs will be drawn.
Repeat as needed then press Enter or Esc to end the command.
Prompts
Enter C/L intersection point
(Enter when done): enter or pick the intersection point of
the two road centerlines.
Enter 1st road C/L bearing
[Arc]: If first road is straight, enter the 1st
bearing. If it is an Arc, enter the 1st radius point.
Enter 1st road width: Enter 2nd
road C/L bearing (Arc): If the intersection point for the
first road centerline is on a straight segment, enter the bearing
of the centerline. If it is on an arc, type A and <Enter>
then enter the first road centerline’s radius point.
Enter 2nd road width: Enter
the second road width.
Enter 2nd road C/L bearing
[Arc]: Enter the second road centerline bearing or type A
and <Enter> and specify the centerline radius point for the
second road.
Enter fillet radius: Enter
the fillet radius or zero, if there are no fillets.
Pulldown Menu Location:
CG-Survey > Cogo > Roadways >
Intersections/Cul-de-sacs
Keyboard Command:
cg_xint
Prerequiste:
coordinate file