This feature allows you to calculate the right-of-way intersection
points and/or the fillet points and fillet radius points (if
fillets are used) at T type intersections. One or both of the roads
may have arc centerlines.
The points
defining the fillet points will be calculated and stored in the
coordinate file. Repeat as needed or press <Esc> or
<Enter> at the Enter C/L intersection point (Enter when
done): prompt to end the command.
Prompts
Enter C/L intersection point
(Enter when done): enter or pick the centerline intersection
point. Enter through road C/L bearing
[Arc] <0.000000>: If the through road is a straight
road, enter or pick the bearing for the road. Otherwise type A and
<Enter> to switch to Arc mode and enter the radius point of
the through road. Enter through road width
<0.000000>: Enter the width of the through road. Enter 2nd road C/L bearing away
from intersection [Arc] <0.000>: enter the 2nd bearing
or press <A> for Arc and enter the radius point. The bearing
is away from the intersection. Enter 2nd road width
<0.000>: Enter the 2nd road width. Enter fillet radius
<0.000>: If you do not want to have fillets, press
<Enter> to use the 0.00 default value. Otherwise, enter the
fillet radius.