Mine Note Auto Left/Right is a simple routine for entering offsets. The routine only requires a starting and ending point, and then simply distance up, distance left, and distance right over and over until the end of that entry. Corner points may be specified for left or right offsets by preceding the number with a C or *. Corner points identify a corner of a pillar across a cross cut. Corner points are drawn as green dots, while other points are red circles. This distinction is made to assist in pillar connections and is important for AutoMine Connections.
If the ASCII File From Notes option is on, this routine also produces a .DAT file in the data directory which contains a record of the entries. This file is necessary for AutoMine Connections.
Enter Offset File Name <offset.dat>: press
Enter
Enter/Pick From Station Point: pick or enter a
point
Entry Number: 1 This is an identification number for
the entries that follow. AutoMine Connections groups spad offsets
by this number.
Enter/Pick To Station Point (a for azimuth): pick or
enter a point or enter A
Spad Number or <Enter> for none: 1043 This
number is drawn at the spad.
Flip Spad Text (Y/<N>)? N This determines the
orientation of the spad text.
Enter Distance From Station on Centerline (U to Undo, Enter to
end): 25
Enter Left Offset Distance: C10 The C specifies a
left corner point.
Enter Right Offset Distance: 8
Pulldown Menu Location: Notes
Keyboard Command: note2
Prerequisite: None