Draw Strata Cut Depth Contours
This command will draw the Strata
Cut Depth Contours. This command creates contours for
the cut depth between the design surface and strata.
You must have created Strata Surfaces through the Make Strata Surface command.
Then select Draw Strata Cut Depth
Contours from the Drillhole
menu. You will be prompted to select the Strata from
the dialog box below. You can assign a contour
interval and contour layer for the contours to be drawn. If
Use Inclusion/Exclusion
Perimeters is checked on you will be prompted for an
Inclusion polyline and an Exclusion polyline if needed, otherwise
the drawing's Boundary linework will be used.
Keyboard Command:
tk_chdepth
Prerequisite: Make Strata
Surface