This command takes a surface polyline drawn with a spoil pile
and flattens the top of the spoil pile. There are two methods to
set the flatten width. The By Distance method sets the horizontal
distance across the top to equal the user-specified distance. The
By Height method sets the elevation of the flatten to the specified
height above a reference point like the pit floor. With this
method, the program will prompt to pick the reference
point.
The flatten direction will either push to the left, right or both directions. This step can be stored to a sequence file (.seq) for the Process Dragline Sequence command.
Before Flatten Spoil Top |
After Flatten Spoil Top |
Select pile to flatten: pick the surface polyline near the top of the spoil pile
Pulldown Menu Location: Surface in the Mining Module
Keyboard Command: spoil
Prerequisite: Surface polyline in profile view with
spoils