This command creates a sewer network by placing structures on
polyline vertices. Before running this command, draw a polyline
connecting where you want to create structures. An advantage of
this command over Create Sewer Structure is that the polyline
defines the connections between the structures. Also before running
this routine, go to Sewer Network Settings to assign the Network
File, Surface File and settings.
In the options dialog, set the default values for the structures
and pipes. See the Create Sewer Structure topic for information on
these settings.
After the dialog, the program prompts to select the polyline.
Then temporary arrows are drawn to show the flow direction that the
program will use. There is a prompt to reverse this direction if
needed. Then the program creates structures at each vertice in the
polyline. The design settings such as Min Cover and Min Slope from
Sewer Network Settings are used to set the pipe slopes and invert
elevations. After creating the structures, the Edit Sewer Structure
dialog shows the new structures. You can review and edit the
structure properties.
Input Sewer Line dialog
Select Network Polyline: pick a polyline
Switch flow direction [Yes/<No>]? press
Enter
Edit Sewer Structure dialog
Pulldown Menu Location: Network
Keyboard Command: plswr
Prerequisite: polyline and Sewer Network Settings