This command reports drillholes located at the same
easting/northing position. The holes can have different names. The
report dialog displays the names, and locations of the problem
holes. The command has an option to draw a circle, of specified
size, around the holes that are found duplicate. The purpose of
this routine is to help clean up the drillhole database by
identifying duplicate position drillholes since the modeling can
only process one drillhole at any one location. This routine only
shows the duplicates and it is up to you to actually decide which
duplicate drillholes to remove or move. It does not report two
drillholes that have the same name, but are at different
locations.
Draw circle around duplicate drillholes [Yes/<No>]?
Y
Circle radius <100.0>: press Enter for 100
Pulldown Menu Location: Drillhole > Reports
Keyboard Command: dupch
Prerequisite: Drillholes