Draw Perimeter creates a polyline in the PERIM layer out of the points you pick. These points should compose the perimeter of a mine section. It is necessary to end picking points, and by entering C in order to make a closed polyline. The polyline must be closed, or inaccurate tonnages may result. Before using this routine, the points to connect can be placed using one of the Mine Note Entry commands.
[qui end,node on] First Point: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: C for close
Pulldown Menu Location: Works
Keyboard Command: perim
Prerequisite: None