When changes are made to the panels that result in a change in
the extraction ratio this function must be run to update the
extraction ratio in the panels. This also must be run after placing
panels using Auto-Place Panels by text. If the text values for
extraction are used to input the extraction ratio for advance or
retreat extraction ratios this function must be run. Text for the
extraction ratio must be put on the CAD layer of EXTRACTION. Two other layer
names that will be recognized by this command to update the panels
are ATTR_GROUP to
assign a certain Panel Attribute Group to certain panels (such as
longwall vs. continuous miner), and ENTRY_WIDTH to set that to the
value of the text in that layer.
Select all panel polylines to
have extraction ratio updated:
Select objects: Specify opposite corner: 6 found
Select objects:
Polyline offset amount <0.0>: press Enter
Retreat recovery
<1.0>: 0
Panel
5 RIGHT has extraction of 0.48000
Panel 4 RIGHT has extraction of
0.48000
Panel 3 RIGHT has extraction of
0.48000
Panel 2 RIGHT has extraction of
0.48000
Panel 1 RIGHT has extraction of
0.48000
Panel N_MAINS has extraction of
0.55000
Pulldown Menu Location: AdvMine
Keyboard Command: redoextract