Edit Panel
The function is identical to the section definition portion of
Place Panel function. It is used to edit properties of the section
of the panel after the panel has been completed. The precedence can
be set by either picking from the list, or screen picking.
- Panel name: This is a
required field.
- Panel start: This is an
optional field. The Underground Timing routine have an option
for start date that usually makes this field unnecessary. This
field can delay the start of a panel independently of the plan
start date.
- Easting: The easting
coordinate value of the first picked point when the panel was
placed.
- Northing: The northing
coordinate value of the first picked point when the panel was
placed.
- Azimuth: The azimuth
from the first to the second picked points when the panel was
placed.
- Entry Width: This is
used to calculate face feet/meters of advance. This should be set
to the width of the panel when working with longwall panels to get
the correct advance down the panel.
- Prompt for coal
qualities: A check in this box brings up the Define panel
Attributes dialog box.
- Prompt for retreat
options: The following prompts appear that allow for a
second polygon that specifies a second area that can be retreat
mined separate from the area mined on the advance. This additional
polyline must be closed and can be totally contained in the advance
polyline, overlap, or be outside. When the polyline overlaps two
options exist: the extraction ratio for the area contained in
the advance polyline and the area outside of the advance mining
polyline.
Command Line Prompt:
Pick a polyline representing a shape of the
retreat area:
Enter the extraction ratio for
remaining pillars: .25
Enter the extraction ratio for
COAL outside the panel: 0
- Retreat Extraction: Any
entry in this box other than the default zero will place a second
mining panel that can be scheduled on the retreat back through the
panel.
- Owner: A single owner's
name can be assigned to the panel.
- Precedence: This box
gives the opportunity to set fixed scheduling relationships. Any
panels selected must be completed before this panel can
start.
- Advance Difficulty
Factor: A value or a grid can be used to provide difficulty
factor input for advance mining in the panel.
- Retreat Difficulty
Factor: A second value or grid can be specified for retreat
mining independent of the advance mining difficulty rate.
Pulldown Menu Location: UnderGnd
Keyboard Command: edit_panel