Mine Map Insert Commands

Here are ten very useful drawing embellishment commands. Add Core Hole, Bench Marks, Bottom Elev Points, Mine Name, Section Name, Stoppings, Escapeways (solid circle), Takeup Date, and N-E Line are straight forward routines that place their corresponding information in the drawing using the standard layer name, color, font and height. The prompts for all nine inserts, as well as the Revise Bottom Elev Points routine, are listed below.

Prompts

For Add Core Hole:
Enter or pick 'x' and 'y' co-or of corehole location: pick a point
Corehole name: DH-8332
Surface elevation: 2115.30
Bottom of coal seam elevation: 1521
Total coal in inches: 65
Total impurities in inches: 4

For Bench Marks:
[node on] Pick Location Of Benchmark Elevation: pick a point
Enter BM Number: 834
Enter Elevation of BM: 734.65
Additional Text (Enter if none): V18-P
Pick Location For The BM Text: pick a point
Pick Alignment Point For Text: pick a point

For Bottom Elev Points:
Elevation : 1231
Pick pt. for elevation mark 'x' : pick a point
Pick point at beginning of label: pick a point
Pick point for label alignment: pick a point

For Revise Bottom Elev Points:
Select Bottom Elevation Marks & Text to Revise: pick object

For Mine Name:
Company name : Carlson Mining Company
Mine name : Carlson No,1
MSHA I.D. N.O.: 8332
State I.D. N.O. : 21153
Pick point at beginning of label: pick a point
Pick point for label alignment: pick a point

For Section Name:
Degrees of panel azimuth: 90
Minutes of panel azimuth: 00
Seconds of panel azimuth: 32
Panel name : North Mains
Panel I.D. n.o. : 2338
Panel in date : 3/1/05
Panel out date : 4/1/05
Additional notes : 60'x60' Centers
Pick point at beginning of label: pick a point
Pick point for label alignment: pick a point

For Stoppings:
Pick point for beginning of stopping line orientation: pick a point
Pick point for end of stopping line orientation: pick a point
Pick point to beginning stopping: pick a point
Pick point to end stopping: pick a point

For Escapeways:
Pick pt. for escapeway symbol: pick a point

For Takeup Date:
Takeup date [ mm-dd-yy format ]: 3-1-05
Pick point at beginning of label: pick a point
Pick point for label alignment: pick a point

For N-E Line:
Enter Northing: 5000
Enter Easting : 5000
This will be placed in the drawing at the corresponding northing and easting.

Pulldown Menu Location: Notes
Keyboard Commands: chole, benchmark, botelev, botelev2, mname, sname, stop, xways, tdate, neline.
Prerequisite: None