Remove Trench Network Structure
This command removes the existing trench structure data. There has
to be a trench network structure that has been created beforehand
and its data is store in a .sew file whose name is as same as the
drawing name. The command first prompts you to pick a sewer
structure on the drawing or to select from a List of your Sewer
Structures. If there is no such structure in the file, you will get
an error message like this: "Error: unable to locate structure in
file C:\temp\takeoff\SANI1x.sew, otherwise this command removes the
structure from both the drawing and the .sew file immediately. You
are prompted to remove another structure point until you press
Enter to finish. The
removed trench structure points would no longer be found in the
.sew file.
Prompts
Select structures to erase by
screen pick or name list [<Pick>/List]? Pick to choose
from the screen, or List to choose from the below
dialog.
Prerequisite: Your drawing
is open, has been cleaned up and pre-processed by such commands as
Define Layer Target, Set Boundary Polyline, Make Existing Ground
Surface and Make Design Surface. Trench structure data has been
stored in a .sew file, whose name is as same as the drawing
name.
Keyboard Command:
remove_trench