Draw Strata Cut Depth Contours

This command will draw the Strata Cut Depth Contours. This command creates contours for the cut depth between the design surface and strata.

You must have created Strata Surfaces through the Make Strata Surface command.

Then select Draw Strata Cut Depth Contours from the Drillhole menu. You will be prompted to select the Strata from the dialog box below.

You can assign a contour interval and contour layer for the contours to be drawn. If Use Inclusion/Exclusion Perimeters is checked on you will be prompted for an Inclusion polyline and an Exclusion polyline if needed, otherwise the drawing's Boundary linework will be used.

Keyboard Command: tk_chdepth
Prerequisite: Make Strata Surface