Other Drawing
This command allows you to display all the entities on the layers
that are grouped as part of the Other drawing.
Carlson TakeOff allows you to
assign layers into three different "Target" surface groups:
Existing, Design, and Other. For more about assigning layers to
different "Target" surface groups see Define Layer
Target/Material/Subgrade under the tools menu. Once layers have
been assigned, the display menu allows for easy viewing of each
"Target" surface. Typically, most layers are listed under Other
before they are assigned to Existing or Design. Some layers, like
perimeter, are neither apart of the Existing or the Design drawing
so they remain under Other. When Other Drawing is checked than the
entities grouped under Other will be displayed. If it is not
checked it will not be displayed. You can check on and off the
other "Target" surfaces to view the Other surface in isolation or
in accordance to the other surfaces. In this example, Existing,
Design, and Other are all shown.
Keyboard Command: set_display_other_dwg
Prerequisite: Define Layer
Target/Material/Subgrade