This command is similar to Bearing-Bearing Intersect except that in this command bearings are defined by specifying two point numbers. In the example shown below, the first two points specified are 3838 and 3839, the second pair are 3841 and 3840. Point 3842 is located at the intersection.
Specify 1st base point.
Pick point or point number: 3838
Specify 2nd point that defines 1st direction.
Pick point or point number: 3839
Specify 2nd base point.
Pick point or point number:3841
Specify 2nd point that defines 2nd direction.
Pick point or point number: 3840
Select/<Enter Point Elevation>: Enter value
Pulldown Menu Location: COGO > Locate at Intersect
Keyboard Command: bbint2
Prerequisite: None