This command draws a series of parking stalls. The command prompts for stall width and length, stall parking angle, and side for stalls. Stalls can be located by the number of stalls in a direction, as many as fit between two points, or along a polyline.
Stall Layout Method: Indicate the method of stall creation whether it be a desired number of stalls or as many stalls as can be fit on an alignment.
Min Stall Width: Indicate the minimum width a stall can be when the Fit on Alignment option is specified.
Max Stall Width: Indicate the maximum width a stall can be when the Fit on Alignment option is specified.
Stall Width: Indicate the stall width when the Number of Stalls option is specified.
Number of Stalls: Indicate the desired number of stalls when the Number of Stalls option is specified.
Stall Length: Indicate the desired length of each stall.
Side for Stalls: Indicate the side to which the stall lines should be placed.
Stall Placement Method: Indicate the method by which the stall direction should be determined whether it be between two picked points or along an existing graphical alignment.
Layer: Specify the layer on which parking lines should be placed or click the Set button to choose an existing layer.
Starting Point?
Pick point or point number:
Pick a point
Ending Point?
Pick point or point number:
Pick a point
Created 10 stalls.
Pulldown Menu Location(s):
Civil → Area/Layout → Layout Utilities,
Survey → Area/Layout → Layout Utilities
Keyboard Command: parking
Prerequisite: None.