Lot Network Linework
The following commands allow for the Lot Network to be manipulated
after the processing. The commands allowing this are:
Add ROW Polyline
Adds a ROW polyline into the model. By clicking this command, the
software asks for the user to select the new ROW polyline. It then
reprocesses the site based on this new ROW data and relocates the
EOP for this portion of the roadway.
Add Lot Edge
This command adds a lot edge to the model. The software may request
a Lotnet Settings file and if so create or select it. The software
prompts with: Select Edge linework to add to model: Select the
polyline you drew in the lot representing the new lot edge. The
software reprocesses the site based on this new data and redevelops
the lot layout accordingly.
Remove Lot Edge
This takes a property line out of the model. Select the edge in
question when prompted.
Add Lot Edge Point
This command allows for adding a new property corner to an existing
lotline. Simply select the lot edge in question and then pick the
point to be added using a snap or other means.
Move Lot Edge Point
This command allows for moving a lot corner.
Remove Lot Edge Point
This command allows for eliminating a lot corner. Simply select the
lot edge in question and then the corner to be removed.
Pulldown Menu Location: Area/Layout
Keyboard Command: Lotnet_Add_Row, Lotnet_Add_Edge,
Lotnet_Remove_Edge, Lotnet_Point_Add, Lotnet_Point_Edit,
Lotnet_Point_Remove
Prerequisite: None