Spoil by Interior Point
This routine is used to create spoil polylines from the existing
linework by making closed polylines around points picked. The site
and spoil names are user-specified and the spoil name is
incremented after each new pile perimeter is created. This command
uses the Boundary Polyline logic, using any linework (open or
closed) and searches out from the picked point for the closed
perimeter. It draws a new polyline in the specified layer.
- Label Area Names:
Choose whether to label the pile perimeters or not
- Text Height: Set the
text height in feet or meters based on the drawing setup
- AutoPlace Labels in
Center: Yes to put the text insertion point on the centroid
of the perimeter
- Layer Name: Select or
enter the layer name to draw the perimeter and text
- Site Name: Specify a
site name to give to all the new pile perimeters
- Spoil Name: Specify a
name to give the first pile perimeter. Subsequent piles will
increment the name by one automatically.
Prompts
Pick point inside pile perimeter: pick inside a loop or
linework representing the pile for the spoil polyline
Specify another area (<Yes>/No)? If yes is selected,
then the Pile Name is automatically incremented by one for
efficient entry, such as Spoil 2. Site name <Site 1>:
Pit name <Spoil 2>:
Pulldown Menu Location: Spoil in Surface Mine Module
Keyboard Command: pickspoil