This routine looks at all the pits and benches and removes the
bench completely from the pit if the volume and/or tons are less
than the specified tolerance. This is useful to remove very small
quantities that have been stored in pits by mistake, or just from
calculations on the edges of the data. Running this command will
remove the pit bench with volume below the tolerance, so when
running timing routines, the pits won't show up. This is useful for
the 3D Pick option in Surface Equipment Timing to remove upper
benches that are in the pit, but have no volume assigned.
Command: emptypit
Key volume tolerance (CY)
<0.0>: 100
Non-Key volume tolerance (CY)
<0.0>: 100
Key tons tolerance
<0.0>: 100
Select pit polylines to remove
empty benches.
Select objects: all
7 found
Removed 2 empty
benches.