Polyline to Right of Way

This command adds right of way information to a centerline file which must be created before running this command. The right of way is created by selecting a polyline that represents the right of way. The station and offset for each point relative to the centerline is stored as the right of way data in the centerline file. There are two applications for this data. The Draw/Label Right of Way command can be used to label each point with the station and offset. Also this data can also be used in Process Road Design to limit the cut/fill slopes.

Prompts

Choose Centerline to Process Specify a centerline file.
Polyline should have been drawn in direction of increasing stations.
Select polyline that represents right of way: pick a polyline
Side to apply right of way (<Left>/Right)? press Enter

Pulldown Menu Location: Centerline
Keyboard Command: rowpl
Prerequisite: A polyline and centerline file